Witam
Wgrałem przez gui gargoyle i poszło prawie ok ale nie mogłem się do niego dostać.  Więc postanowiłem wgrać raz jeszcze, tym razem przez com. Wszystko według instrukcji z eko.one.pl (adres karty 192.168.1.27),lecz wciąż operacja kończy się tym:

U-Boot 1.1.4 (Jul  3 2012 - 15:12:08)

U-boot AP123

DRAM:  32 MB
id read 0x100000ff
Flash:  4 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ag934x_enet_initialize...
wasp reset mask:c03300
WASP ----> S27 PHY
GMAC: cfg1 0x5 cfg2 0x7114
eth0: ba:be:fa:ce:08:41
s27 reg init
athrs27_phy_setup ATHR_PHY_CONTROL 4: 0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4: 0x10
eth0 up
WASP ----> S27 PHY
GMAC: cfg1 0xf cfg2 0x7214
eth1: ba:be:fa:ce:08:41
s27 reg init lan
ATHRS27: resetting s27
ATHRS27: s27 reset done
athrs27_phy_setup ATHR_PHY_CONTROL 0: 0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 0: 0x10
athrs27_phy_setup ATHR_PHY_CONTROL 1: 0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1: 0x10
athrs27_phy_setup ATHR_PHY_CONTROL 2: 0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2: 0x10
athrs27_phy_setup ATHR_PHY_CONTROL 3: 0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3: 0x10
eth1 up
eth0, eth1
Autobooting in 1 seconds
wasp> erase 0x9f020000 +0x3c0000

First 0x2 last 0x3d sector size 0x10000                                       61
Erased 60 sectors
wasp> tftpboot 0x81000000 code.bin
enet1 port1 up
dup 1 speed 1000
Using eth1 device
TFTP from server 192.168.1.100; our IP address is 192.168.1.111
Filename 'code.bin'.
Load address: 0x81000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
eth0 link down
Using eth1 device
TFTP from server 192.168.1.100; our IP address is 192.168.1.111
Filename 'code.bin'.
Load address: 0x81000000
Loading: T T T T T T T