Temat: TP-Link TL-MR3420 + usb wifi TP-Link TL-WN722N
Zamontowałem do routera TP-Link TL-MR3420 kartę usb wifi TP-Link TL-WN722N
Załadowałem moduły (możliwe, że nie wszystkie są potrzebne)
kmod-ath
kmod-ath9k
kmod-ath9k-common
kmod-ath9k-htc
/proc/bus/usb/devices:
T: Bus=01 Lev=02 Prnt=02 Port=01 Cnt=02 Dev#= 4 Spd=480 MxCh= 0
D: Ver= 2.00 Cls=ff(vend.) Sub=ff Prot=ff MxPS=64 #Cfgs= 1
P: Vendor=0cf3 ProdID=9271 Rev= 1.08
S: Manufacturer=ATHEROS
S: Product=USB2.0 WLAN
S: SerialNumber=12345
C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=500mA
I:* If#= 0 Alt= 0 #EPs= 6 Cls=ff(vend.) Sub=00 Prot=00 Driver=ath9k_htc
E: Ad=01(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E: Ad=82(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E: Ad=83(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=04(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=05(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E: Ad=06(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
root@OpenWrt:~# lsusb
Bus 001 Device 004: ID 0cf3:9271 Atheros Communications, Inc. AR9271 802.11n
root@OpenWrt:~# iwconfig
wlan1 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=0 dBm
RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
wlan0 IEEE 802.11bgn Mode:Master Frequency:2.412 GHz Tx-Power=17 dBm
RTS thr:off Fragment thr:off
Power Management:on
mon.wlan0 IEEE 802.11bgn Mode:Monitor Frequency:2.412 GHz Tx-Power=17 dBm
RTS thr:off Fragment thr:off
Power Management:on
"wlan0" to interfejs wbudowany w router.
Nie widzę interfejsu w LUCI. W Network>Wifi jest tylko wbudowane w router radio [radio0: Master "TPLINK"].
Chcę skonfigurować wlan1 jako backupowy wan. Najchętniej żebym mógł robić scanning w LUCI.
W jaki sposób LUCI rozróżnia interfejsy wifi? Ja to robię przez "iwconfig". Ale interfejsy w iwconfigu nazywają się wlan0 i wlan1 a w LUCI "radio0" i chyba powinno pojawić się "radio1"???
Jakieś propozycje co dalej robić?
Pozdrawiam
Michał