[ 194.201313] reboot: Restarting system
__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** WNC BOARD: Viper R2.2 LE **
** For Development Only. Not For Demo **
U-Boot 1.1.4 (Sep 15 2011 - 15:46:36) Marvell version: 3.5.9
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CFB20
Soc: 88F6282 A1CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM (DDR2) CAS Latency = 6 tRP = 6 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 128MB
DRAM Total size 128MB 16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:128 MB
Updating boot_count ... done
Flash: 0 kB
CPU : Marvell Feroceon (Rev 1)
u_env Offset: 00080000
s_env Offset: 000a0000
Streaming disabled
Write allocate disabled
Module 0 is RGMII
USB 0: host mode
PEX 0: PCI Express Root Complex Interface
PEX interface detected Link X1
PEX 1: PCI Express Root Complex Interface
PEX interface detected Link X1
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x200000, size 0x300000
Reading data from 0x4ff800 -- 100% complete.
3145728 bytes read: OK
## Booting image at 02000000 ...
Image Name: ARM OpenWrt Linux-6.6.93
Created: 2025-06-23 20:40:36 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3246431 Bytes = 3.1 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... Bad Data CRC
Viper>>
tak się kończy start z nowego obrazu, przetestowałem 2,