# ls /tmp/usb_mount
3F973A6154E8125A                      8a991ade-31f1-44e6-8ed0-caf5c8724ed0  f4dab526-024b-456c-b1d5-9e31365f7aff

# mount
rootfs on / type rootfs (rw)
/dev/root on /rom type squashfs (ro,relatime)
proc on /proc type proc (rw,relatime)
sysfs on /sys type sysfs (rw,relatime)
tmpfs on /tmp type tmpfs (rw,nosuid,nodev,relatime)
tmpfs on /dev type tmpfs (rw,relatime,size=512k,mode=755)
devpts on /dev/pts type devpts (rw,relatime,mode=600)
/dev/mtdblock3 on /overlay type jffs2 (rw,relatime)
mini_fo:/overlay on / type mini_fo (rw,relatime)
debugfs on /sys/kernel/debug type debugfs (rw,relatime)
none on /proc/bus/usb type usbfs (rw,relatime)

# ls /tmp/usb_mount
3F973A6154E8125A                      8a991ade-31f1-44e6-8ed0-caf5c8724ed0  f4dab526-024b-456c-b1d5-9e31365f7af

Feb 18 23:24:21 Gargoyle user.warn kernel: EXT2-fs warning (device sda1): ext2_fill_super: mounting ext3 filesystem as ext2
Feb 18 23:24:21 Gargoyle user.warn kernel: EXT2-fs warning: maximal mount count reached, running e2fsck is recommended

# e2fsck /dev/sda1
e2fsck 1.41.11 (14-Mar-2010)
/dev/sda1 has been mounted 42 times without being checked, check forced.
Pass 1: Checking inodes, blocks, and sizes
Error allocating block bitmap (1): Memory allocation failed
e2fsck: aborted
root@Gargoyle:~# e2fsck /dev/sda2
e2fsck 1.41.11 (14-Mar-2010)
e2fsck: Superblock invalid, trying backup blocks...
e2fsck: Bad magic number in super-block while trying to open /dev/sda2

The superblock could not be read or does not describe a correct ext2
filesystem.  If the device is valid and it really contains an ext2
filesystem (and not swap or ufs or something else), then the superblock
is corrupt, and you might try running e2fsck with an alternate superblock:
    e2fsck -b 8193 <device>

root@Gargoyle:~# e2fsck /dev/sda3
e2fsck 1.41.11 (14-Mar-2010)
/dev/sda3: clean, 11/51200 files, 8013/204800 blocks
root@Gargoyle:~# e2fsck /dev/sda4
e2fsck 1.41.11 (14-Mar-2010)
e2fsck: Superblock invalid, trying backup blocks...
e2fsck: Bad magic number in super-block while trying to open /dev/sda4

The superblock could not be read or does not describe a correct ext2
filesystem.  If the device is valid and it really contains an ext2
filesystem (and not swap or ufs or something else), then the superblock
is corrupt, and you might try running e2fsck with an alternate superblock:
    e2fsck -b 8193 <device>

# fdisk /dev/sda
Note: sector size is 1024 (not 512)
Device contains neither a valid DOS partition table, nor Sun, SGI or OSF disklabel
Building a new DOS disklabel with disk identifier 0xe7b78e8d.
Changes will remain in memory only, until you decide to write them.
After that, of course, the previous content won't be recoverable.


The number of cylinders for this disk is set to 38912.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
   (e.g., DOS FDISK, OS/2 FDISK)
Warning: invalid flag 0x0000 of partition table 4 will be corrected by w(rite)

Command (m for help): p

Disk /dev/sda: 640.1 GB, 640135028736 bytes
255 heads, 63 sectors/track, 38912 cylinders
Units = cylinders of 16065 * 1024 = 16450560 bytes
Disk identifier: 0xe7b78e8d

   Device Boot      Start         End      Blocks   Id  System

Command (m for help): n
Command action
   e   extended
   p   primary partition (1-4)
e
Partition number (1-4): ^C
root@Gargoyle:~# fdisk /dev/sda
Note: sector size is 1024 (not 512)
Device contains neither a valid DOS partition table, nor Sun, SGI or OSF disklabel
Building a new DOS disklabel with disk identifier 0x52115dce.
Changes will remain in memory only, until you decide to write them.
After that, of course, the previous content won't be recoverable.


The number of cylinders for this disk is set to 38912.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
   (e.g., DOS FDISK, OS/2 FDISK)
Warning: invalid flag 0x0000 of partition table 4 will be corrected by w(rite)

Command (m for help): n
Command action
   e   extended
   p   primary partition (1-4)
n
Invalid partition number for type `n'
Command action
   e   extended
   p   primary partition (1-4)
p
Partition number (1-4): 1
First cylinder (1-38912, default 1):
Using default value 1
Last cylinder or +size or +sizeM or +sizeK (1-38912, default 38912): 800

Command (m for help): n
Command action
   e   extended
   p   primary partition (1-4)
p
Partition number (1-4): 2
First cylinder (801-38912, default 801):
Using default value 801
Last cylinder or +size or +sizeM or +sizeK (801-38912, default 38912): t
Last cylinder or +size or +sizeM or +sizeK (801-38912, default 38912): 1014

Command (m for help): p

Disk /dev/sda: 640.1 GB, 640135028736 bytes
255 heads, 63 sectors/track, 38912 cylinders
Units = cylinders of 16065 * 1024 = 16450560 bytes
Disk identifier: 0x52115dce

   Device Boot      Start         End      Blocks   Id  System
/dev/sda1               1         800    12851937   83  Linux
/dev/sda2             801        1014     3437910   83  Linux

Command (m for help): n
Command action
   e   extended
   p   primary partition (1-4)
p
Partition number (1-4): 3
First cylinder (1015-38912, default 1015):
Using default value 1015
Last cylinder or +size or +sizeM or +sizeK (1015-38912, default 38912):
Using default value 38912

Command (m for help):

/dev/sda3   /mnt/sda3   ext3   rw   0   0

    config mount
        option target /mnt/sda3
        option device /dev/sda3
        option fstype ext3
        option options rw,noatime
        option enabled 1
        option enabled_fsck 0

config global automount
        option from_fstab 1
        option anon_mount 1

config global autoswap
        option from_fstab 1
        option anon_swap 0

config mount
        option target   /home
        option device   /dev/sda1
        option fstype   ext3
        option options  rw,sync
        option enabled  0
        option enabled_fsck 0
config mount
        option target   /mnt/sda3
        option device   /dev/sda3
        option fstype   ext3
        option options  rw,noatime
        option enabled  1
        option enabled_fsck 0

config swap
#       option device   /dev/sda2
        option uuid     29fe5b6d-8187-464b-b2d7-641e46aecaf7
        option enabled  1

# wget http://www.mydefrag.com/Downloads/Download.php?File=MyDefr
ag-v4.3.1.exe /mnt/sda3/a.exe

# ls /mnt/sda3
lost+found