podczas aktualizacji uwaliłem swojego 1043ND v1
Znalazłem u siebie zamiennik kabla CA42.
Podłączyłem uruchomiłem putty i otrzymuje takie coś

U-Boot 1.1.4 (Apr 28 2013 - 16:01:02)

AP83 (ar9100) U-boot 0.0.11
DRAM:
sri
32 MB
id read 0x100000ff
flash size 8MB, sector count = 128
Flash:  8 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ag7100_enet_initialize...
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...

OpenWrt kernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos <juhosg@openwrt.org>
Looking for OpenWrt image... found at 0xbf022000
Decompressing kernel... done!
Starting kernel at 80060000...

[    0.000000] Linux version 3.3.8 (cezary@eko.one.pl) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #24 Sat Jun 14 11:34:52 CEST 2014
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU revision is: 00019374 (MIPS 24Kc)
[    0.000000] SoC: Atheros AR9132 rev 2
[    0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:5.000MHz
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 02000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] Zone PFN ranges:
[    0.000000]   Normal   0x00000000 -> 0x00002000
[    0.000000] Movable zone start PFN for each node
[    0.000000] Early memory PFN ranges
[    0.000000]     0: 0x00000000 -> 0x00002000
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
[    0.000000] Kernel command line:  board=TL-WR1043ND console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[    0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[    0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[    0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[    0.000000] Writing ErrCtl register=00000000
[    0.000000] Readback ErrCtl register=00000000
[    0.000000] Memory: 28936k/32768k available (2256k kernel code, 3832k reserved, 425k data, 220k init, 0k highmem)
[    0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:51
[    0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
[    0.080000] pid_max: default: 32768 minimum: 301
[    0.080000] Mount-cache hash table entries: 512
[    0.090000] NET: Registered protocol family 16
[    0.090000] gpiochip_add: registered GPIOs 0 to 21 on device: ath79
[    0.100000] MIPS: machine is TP-LINK TL-WR1043ND
[    0.360000] bio: create slab <bio-0> at 0
[    0.370000] Switching to clocksource MIPS
[    0.380000] NET: Registered protocol family 2
[    0.380000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.380000] TCP established hash table entries: 1024 (order: 1, 8192 bytes)
[    0.390000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.390000] TCP: Hash tables configured (established 1024 bind 1024)
[    0.400000] TCP reno registered
[    0.400000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.410000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.420000] NET: Registered protocol family 1
[    0.440000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    0.440000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    0.450000] msgmni has been set to 56
[    0.460000] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254)
[    0.460000] io scheduler noop registered
[    0.470000] io scheduler deadline registered (default)
[    0.470000] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled
[    0.510000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
[    0.510000] console [ttyS0] enabled, bootconsole disabled
[    0.510000] console [ttyS0] enabled, bootconsole disabled
[    0.530000] m25p80 spi0.0: found s25fl064k, expected m25p80
[    0.530000] m25p80 spi0.0: s25fl064k (8192 Kbytes)
[    0.540000] 5 tp-link partitions found on MTD device spi0.0
[    0.540000] Creating 5 MTD partitions on "spi0.0":
[    0.550000] 0x000000000000-0x000000020000 : "u-boot"
[    0.560000] 0x000000020000-0x000000110e00 : "kernel"
[    0.560000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[    0.570000] 0x000000110e00-0x0000007f0000 : "rootfs"
[    0.580000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[    0.590000] mtd: partition "rootfs" set to be root filesystem
[    0.600000] mtd: partition "rootfs_data" created automatically, ofs=680000, len=170000
[    0.610000] 0x000000680000-0x0000007f0000 : "rootfs_data"
[    0.620000] 0x0000007f0000-0x000000800000 : "art"
[    0.620000] 0x000000020000-0x0000007f0000 : "firmware"
[    0.630000] Realtek RTL8366RB ethernet switch driver version 0.2.3
[    0.750000] rtl8366rb rtl8366rb: using GPIO pins 18 (SDA) and 19 (SCK)
[    0.750000] rtl8366rb rtl8366rb: RTL5937 ver. 3 chip found
[    0.930000] rtl8366rb: probed
[    0.940000] eth0: Atheros AG71xx at 0xb9000000, irq 4
[    1.240000] TCP cubic registered
[    1.250000] NET: Registered protocol family 17
[    1.250000] Bridge firewalling registered
[    1.260000] Ebtables v2.0 registered
[    1.260000] 8021q: 802.1Q VLAN Support v1.8
[    1.270000] SQUASHFS error: unable to read id index table
[    1.270000] jffs2: Flash size not aligned to erasesize, reducing to 6976KiB
[    1.280000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000000: 0x6873 instead
[    1.290000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000004: 0x9808 instead

... I wiele wiele podobnych ....

[   13.060000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0066001c: 0x03fe instead
[   13.070000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00660020: 0xa86c instead
[   13.080000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00660024: 0xd0f0 instead
[   13.090000] Further such events for this erase block will not be printed
[   13.120000] CLEANMARKER node found at 0x0066f200, not first node in block (0x00660000)
[   13.130000] Node at 0x0066fcfc with length 0x0000048b would run over the end of the erase block
[   13.140000] Perhaps the file system was created with the wrong erase size?
[   13.150000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670000: 0x509c instead
[   13.160000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670004: 0x5462 instead
[   13.160000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670008: 0xf57c instead
[   13.170000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0067000c: 0xa8c4 instead
[   13.180000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670010: 0xc43c instead
[   13.190000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670014: 0x2520 instead
[   13.200000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670018: 0xe49c instead
[   13.210000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0067001c: 0x6bfc instead
[   13.220000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670020: 0x7c75 instead
[   13.230000] jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00670024: 0x96d3 instead
[   13.240000] Further such events for this erase block will not be printed
[   13.270000] CLEANMARKER node found at 0x0067f200, not first node in block (0x00670000)
[   13.280000] JFFS2 notice: (1) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (0 unchecked, 0 orphan) and 29 of xref (0 dead, 4 orphan) found.
[   13.290000] VFS: Mounted root (jffs2 filesystem) readonly on device 31:2.
[   13.300000] Freeing unused kernel memory: 220k freed
[   13.310000] Kernel panic - not syncing: No init found.  Try passing init= option to kernel. See Linux Documentation/init.txt for guidance.

Problem mam taki że w putty nic nie mogę pisać. Czy to może wina kabla ? Czy jest szansa na uratowanie mojego Routera ?