Temat: Serial nie dziala TX TP-LINK TL-WR741ND
Witam,
Ładowałem router przez wifi i oczywiście się wywaliło. Mam serial "http://elkom-serwis.com.pl/konwertery-i … em212.html" i widze co wyrzuca router ale nie moge przerwac procesu ladowania aby cos innego zrobic. zwarlem TX i RX kabla i wydaje sie dzialac. Czy to jest jakis specjalny sygnal aby przerwac proces ladowania?
U-Boot 1.1.4 (Aug 4 2009 - 14:30:03)
AP91 (ar7240) U-boot
DRAM:
sri
#### TAP VALUE 1 = a, 2 = b
32 MB
id read 0x100000ff
flash size 4194304, sector count = 64
Flash: 4 MB
Using default environmentIn: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7014
eth0: 00:03:7f:09:0b:ad
eth0 up
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7214
eth1: 00:03:7f:09:0b:ad
ATHRS26: resetting s26
ATHRS26: s26 reset done
eth1 up
eth0, eth1
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OKStarting kernel ...
Linux version 2.6.32.27 (artek@archbox) (gcc version 4.3.3 (GCC) ) #8 Sun Apr 3 14:46:38 CEST 2011
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR7240 rev 2, CPU:350.000 MHz, AHB:175.000 MHz, DDR:350.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=TL-WR741ND
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29360k/32768k available (2064k kernel code, 3408k reserved, 411k data, 152k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 232.65 BogoMIPS (lpj=1163264)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is TP-LINK TL-WR741ND
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
PCI: fixup device 0000:00:00.0
pci 0000:00:00.0: PME# supported from D0 D1 D3hot
pci 0000:00:00.0: PME# disabled
PCI: mapping irq 48 to pin1@0000:00:00.0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) Š 2001-2006 Red Hat, Inc.
yaffs Apr 3 2011 14:43:27 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: s25sl032a (4096 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x3e0000
Searching for RedBoot partition table in spi0.0 at offset 0x3f0000
No RedBoot partition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 5 MTD partitions on "spi0.0":
0x000000000000-0x000000020000 : "u-boot"
0x000000020000-0x000000160000 : "kernel"
0x000000160000-0x0000003f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=390000, len=60000
0x000000390000-0x0000003f0000 : "rootfs_data"
0x0000003f0000-0x000000400000 : "art"
0x000000020000-0x0000003f0000 : "firmware"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xba000000, irq 5
eth0: Found an AR7240 built-in switch
eth1: Atheros AG71xx at 0xb9000000, irq 4
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
SQUASHFS error: squashfs_read_data failed to read block 0x2267bb
SQUASHFS error: Unable to read metadata cache entry [2267bb]
SQUASHFS error: Unable to read inode 0x1c6e17d6
------------[ cut here ]------------
WARNING: at fs/inode.c:712 0x800ebb6c()
Modules linked in:
Call Trace:[<80068694>] 0x80068694
[<80068694>] 0x80068694
[<8007d23c>] 0x8007d23c
[<800ebb6c>] 0x800ebb6c
[<800ebb6c>] 0x800ebb6c
[<801285e8>] 0x801285e8
[<800ede78>] 0x800ede78
[<80127bf4>] 0x80127bf4
[<80177ec8>] 0x80177ec8
[<800da57c>] 0x800da57c
[<8011f03c>] 0x8011f03c
[<80104b70>] 0x80104b70
[<800dab38>] 0x800dab38
[<800d97f8>] 0x800d97f8
[<800f0c20>] 0x800f0c20
[<801275d4>] 0x801275d4
[<801276a4>] 0x801276a4
[<800d989c>] 0x800d989c
[<800d9998>] 0x800d9998
[<800f1f78>] 0x800f1f78
[<800f2090>] 0x800f2090
[<800e3c4c>] 0x800e3c4c
[<802cbcc4>] 0x802cbcc4
[<801a7ff4>] 0x801a7ff4
[<802cc0c4>] 0x802cc0c4
[<800ab100>] 0x800ab100
[<802cb388>] 0x802cb388
[<8006cb9c>] 0x8006cb9c
[<802cb26c>] 0x802cb26c
[<8006cb8c>] 0x8006cb8c---[ end trace 6f2ce00e8f6ef674 ]---
VFS: Cannot open root device "<NULL>" or unknown-block(31,2)
Please append a correct "root=" boot option; here are the available partitions:
1f00 128 mtdblock0 (driver?)
1f01 ( 1280 mtdblock1 (driver?)
1f02 `2624 mtdblock2 (driver?)
1f03 384 mtdblock3 (driver?)
1f04 864 mtdblock4 (driver?)
1f05 3904 mtdblock5 (driver?)
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)