W logach mam takie coś :
uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Enabling device 01:03.0 (0000 -> 0001)
uhci.c: USB UHCI at I/O 0x100, IRQ 2
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Enabling device 01:03.1 (0000 -> 0001)
uhci.c: USB UHCI at I/O 0x120, IRQ 2
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Enabling device 01:03.2 (0000 -> 0002)
ehci_hcd 01:03.2: PCI device 1106:3104
ehci_hcd 01:03.2: irq 2, pci mem c023b000
usb.c: new USB bus registered, assigned bus number 3
EHCI: Enabling VIA 6212 workarounds
ehci_hcd 01:03.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4
hub.c: USB hub found
hub.c: 4 ports detected
usb.c: registered new driver usblp
printer.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
hub.c: connect-debounce failed, port 1 disabled
hub.c: new USB device 01:03.2-2, assigned address 2
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Kingston Model: DataTraveler 2.0 Rev: PMAP
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 15874048 512-byte hdwr sectors (8128 MB)
sda: Write Protect is off
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
device wl0 entered promiscuous mode
wl0: attempt to add interface with same source address.
br-lan: port 2(wl0) entering learning state
br-lan: port 2(wl0) entering forwarding state
br-lan: topology change detected, propagating
hub.c: new USB device 01:03.0-1, assigned address 2
printer.c: usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2 vid 0x03F0 pid 0x1604
usb.c: USB disconnect on device 01:03.2-2 address 2
Natomiast polecenie df nie pokazuje mi żadnego pendrive'a ...
Co mam wpisać, żeby odpalić pendrive Kingston Date Traveler 8GB (jest sformatowany na FAT32, może ma być FAT ?)....