1

Temat: Odblokowanie kanału 13 na karcie wifi

Mam problem o odblokowaniem kanału 13 na karcie wifi, domyślnie są odblokowane kanały od 1 do 12.

0c:00.0 Unclassified device [0033]: Qualcomm Atheros AR5418 Wireless Network Adapter [AR5008E 802.11(a)bgn] (PCI-Express) (rev 8c)
iw list
Wiphy phy0
    max # scan SSIDs: 4
    max scan IEs length: 2257 bytes
    Retry short limit: 7
    Retry long limit: 4
    Coverage class: 0 (up to 0m)
    Device supports RSN-IBSS.
    Device supports AP-side u-APSD.
    Device supports T-DLS.
    Supported Ciphers:
        * WEP40 (00-0f-ac:1)
        * WEP104 (00-0f-ac:5)
        * TKIP (00-0f-ac:2)
        * CCMP (00-0f-ac:4)
        * 00-0f-ac:10
        * GCMP (00-0f-ac:8)
        * 00-0f-ac:9
    Available Antennas: TX 0x3 RX 0x7
    Configured Antennas: TX 0x3 RX 0x7
    Supported interface modes:
         * IBSS
         * managed
         * AP
         * AP/VLAN
         * WDS
         * monitor
         * mesh point
         * P2P-client
         * P2P-GO
         * Unknown mode (11)
    Band 1:
        Capabilities: 0x104e
            HT20/HT40
            SM Power Save disabled
            RX HT40 SGI
            No RX STBC
            Max AMSDU length: 3839 bytes
            DSSS/CCK HT40
        Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
        Minimum RX AMPDU time spacing: 8 usec (0x06)
        HT TX/RX MCS rate indexes supported: 0-15
        Bitrates (non-HT):
            * 1.0 Mbps
            * 2.0 Mbps (short preamble supported)
            * 5.5 Mbps (short preamble supported)
            * 11.0 Mbps (short preamble supported)
            * 6.0 Mbps
            * 9.0 Mbps
            * 12.0 Mbps
            * 18.0 Mbps
            * 24.0 Mbps
            * 36.0 Mbps
            * 48.0 Mbps
            * 54.0 Mbps
        Frequencies:
            * 2412 MHz [1] (17.0 dBm)
            * 2417 MHz [2] (17.0 dBm)
            * 2422 MHz [3] (17.0 dBm)
            * 2427 MHz [4] (17.0 dBm)
            * 2432 MHz [5] (17.0 dBm)
            * 2437 MHz [6] (17.0 dBm)
            * 2442 MHz [7] (17.0 dBm)
            * 2447 MHz [8] (17.0 dBm)
            * 2452 MHz [9] (17.0 dBm)
            * 2457 MHz [10] (17.0 dBm)
            * 2462 MHz [11] (17.0 dBm)
            * 2467 MHz [12] (17.0 dBm)
            * 2472 MHz [13] (disabled)
            * 2484 MHz [14] (disabled)
    Band 2:
        Capabilities: 0x104e
            HT20/HT40
            SM Power Save disabled
            RX HT40 SGI
            No RX STBC
            Max AMSDU length: 3839 bytes
            DSSS/CCK HT40
        Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
        Minimum RX AMPDU time spacing: 8 usec (0x06)
        HT TX/RX MCS rate indexes supported: 0-15
        Bitrates (non-HT):
            * 6.0 Mbps
            * 9.0 Mbps
            * 12.0 Mbps
            * 18.0 Mbps
            * 24.0 Mbps
            * 36.0 Mbps
            * 48.0 Mbps
            * 54.0 Mbps
        Frequencies:
            * 5180 MHz [36] (13.0 dBm) (no IR)
            * 5200 MHz [40] (17.0 dBm) (no IR)
            * 5220 MHz [44] (17.0 dBm) (no IR)
            * 5240 MHz [48] (17.0 dBm) (no IR)
            * 5260 MHz [52] (17.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5280 MHz [56] (17.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5300 MHz [60] (17.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5320 MHz [64] (17.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5500 MHz [100] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5520 MHz [104] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5540 MHz [108] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5560 MHz [112] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5580 MHz [116] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5600 MHz [120] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5620 MHz [124] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5640 MHz [128] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5660 MHz [132] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5680 MHz [136] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5700 MHz [140] (20.0 dBm) (no IR, radar detection)
              DFS state: usable (for 295 sec)
              DFS CAC time: 60000 ms
            * 5745 MHz [149] (disabled)
            * 5765 MHz [153] (disabled)
            * 5785 MHz [157] (disabled)
            * 5805 MHz [161] (disabled)
            * 5825 MHz [165] (disabled)
    Supported commands:
         * new_interface
         * set_interface
         * new_key
         * start_ap
         * new_station
         * new_mpath
         * set_mesh_config
         * set_bss
         * authenticate
         * associate
         * deauthenticate
         * disassociate
         * join_ibss
         * join_mesh
         * remain_on_channel
         * set_tx_bitrate_mask
         * frame
         * frame_wait_cancel
         * set_wiphy_netns
         * set_channel
         * set_wds_peer
         * tdls_mgmt
         * tdls_oper
         * probe_client
         * set_noack_map
         * register_beacons
         * start_p2p_device
         * set_mcast_rate
         * channel_switch
         * Unknown command (104)
         * connect
         * disconnect
    Supported TX frame types:
         * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
         * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
    Supported RX frame types:
         * IBSS: 0x40 0xb0 0xc0 0xd0
         * managed: 0x40 0xd0
         * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
         * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
         * mesh point: 0xb0 0xc0 0xd0
         * P2P-client: 0x40 0xd0
         * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
         * P2P-device: 0x40 0xd0
    software interface modes (can always be added):
         * AP/VLAN
         * monitor
    valid interface combinations:
         * #{ managed } <= 2048, #{ AP, mesh point } <= 8, #{ P2P-client, P2P-GO } <= 1,
           total <= 2048, #channels <= 1, STA/AP BI must match
         * #{ WDS } <= 2048,
           total <= 2048, #channels <= 1, STA/AP BI must match
    HT Capability overrides:
         * MCS: ff ff ff ff ff ff ff ff ff ff
         * maximum A-MSDU length
         * supported channel width
         * short GI for 40 MHz
         * max A-MPDU length exponent
         * min MPDU start spacing
    Device supports TX status socket option.
    Device supports HT-IBSS.
    Device supports SAE with AUTHENTICATE command
    Device supports low priority scan.
    Device supports scan flush.
    Device supports AP scan.
    Device supports per-vif TX power setting
    P2P GO supports CT window setting
    Driver supports a userspace MPM
    Device supports active monitor (which will ACK incoming frames)
    Driver/device bandwidth changes during BSS lifetime (AP/GO mode)

Linux Mint 18 Cinnamon 32-bit

Linux local 4.4.0-36-generic #55-Ubuntu SMP Thu Aug 11 18:00:59 UTC 2016 i686 i686 i686 GNU/Linux

Jeśli ktoś wie jak to odblokować to będę wdzięczny smile

2

Odp: Odblokowanie kanału 13 na karcie wifi

1. karta może tego nie wspierać
2. przekompiluj sterownik i włącz regdomain
3. a może ma włączone więc ustaw przez iw reg set PL i zobaczy czy się pojawi 12/13

Masz niepotrzebny router, uszkodzony czy nie - chętnie przygarnę go.

3

Odp: Odblokowanie kanału 13 na karcie wifi

Wpisywałem iw reg set PL i nie wyświetlają się kanały.
Podejrzewam że karta tego nie wspiera...

4

Odp: Odblokowanie kanału 13 na karcie wifi

Podmieniłem kartę wifi na inną i działa bez problemu. Nie ma blokady regionalnej.
Dzięki za podpowiedz smile